\n
address_offset : 0x0 Bytes (0x0)
size : 0xC byte (0x0)
mem_usage : registers
protection : not protected
CMT Carrier Generator High Data Register 1
address_offset : 0x0 Bytes (0x0)
size : 8 bit
access : read-write
reset_value : 0x0
reset_Mask : 0x0
PH : Primary Carrier High Time Data Value
bits : 0 - 7 (8 bit)
access : read-write
CMT Carrier Generator Low Data Register 1
address_offset : 0x1 Bytes (0x0)
size : 8 bit
access : read-write
reset_value : 0x0
reset_Mask : 0x0
PL : Primary Carrier Low Time Data Value
bits : 0 - 7 (8 bit)
access : read-write
CMT Carrier Generator High Data Register 2
address_offset : 0x2 Bytes (0x0)
size : 8 bit
access : read-write
reset_value : 0x0
reset_Mask : 0x0
SH : Secondary Carrier High Time Data Value
bits : 0 - 7 (8 bit)
access : read-write
CMT Carrier Generator Low Data Register 2
address_offset : 0x3 Bytes (0x0)
size : 8 bit
access : read-write
reset_value : 0x0
reset_Mask : 0x0
SL : Secondary Carrier Low Time Data Value
bits : 0 - 7 (8 bit)
access : read-write
CMT Output Control Register
address_offset : 0x4 Bytes (0x0)
size : 8 bit
access : read-write
reset_value : 0x0
reset_Mask : 0x0
IROPEN : IRO Pin Enable
bits : 5 - 5 (1 bit)
access : read-write
Enumeration:
#0 : 0
CMT_IRO signal disabled
#1 : 1
CMT_IRO signal enabled as output
End of enumeration elements list.
CMTPOL : CMT Output Polarity
bits : 6 - 6 (1 bit)
access : read-write
Enumeration:
#0 : 0
CMT_IRO signal is active low
#1 : 1
CMT_IRO signal is active high
End of enumeration elements list.
IROL : IRO Latch Control
bits : 7 - 7 (1 bit)
access : read-write
CMT Modulator Status and Control Register
address_offset : 0x5 Bytes (0x0)
size : 8 bit
access : read-write
reset_value : 0x0
reset_Mask : 0x0
MCGEN : Modulator and Carrier Generator Enable
bits : 0 - 0 (1 bit)
access : read-write
Enumeration:
#0 : 0
Modulator and carrier generator disabled
#1 : 1
Modulator and carrier generator enabled
End of enumeration elements list.
EOCIE : End of Cycle Interrupt Enable
bits : 1 - 1 (1 bit)
access : read-write
Enumeration:
#0 : 0
CPU interrupt disabled
#1 : 1
CPU interrupt enabled
End of enumeration elements list.
FSK : FSK Mode Select
bits : 2 - 2 (1 bit)
access : read-write
Enumeration:
#0 : 0
CMT operates in Time or Baseband mode
#1 : 1
CMT operates in FSK mode
End of enumeration elements list.
BASE : Baseband Enable
bits : 3 - 3 (1 bit)
access : read-write
Enumeration:
#0 : 0
Baseband mode disabled
#1 : 1
Baseband mode enabled
End of enumeration elements list.
EXSPC : Extended Space Enable
bits : 4 - 4 (1 bit)
access : read-write
Enumeration:
#0 : 0
Extended space disabled
#1 : 1
Extended space enabled
End of enumeration elements list.
CMTDIV : CMT Clock Divide Prescaler
bits : 5 - 6 (2 bit)
access : read-write
Enumeration:
#00 : 00
IF * 1
#01 : 01
IF * 2
#10 : 10
IF * 4
#11 : 11
IF * 8
End of enumeration elements list.
EOCF : End Of Cycle Status Flag
bits : 7 - 7 (1 bit)
access : read-only
Enumeration:
#0 : 0
No end of modulation cycle occurrence since flag last cleared
#1 : 1
End of modulator cycle has occurred
End of enumeration elements list.
CMT Modulator Data Register Mark High
address_offset : 0x6 Bytes (0x0)
size : 8 bit
access : read-write
reset_value : 0x0
reset_Mask : 0x0
MB : no description available
bits : 0 - 7 (8 bit)
access : read-write
CMT Modulator Data Register Mark Low
address_offset : 0x7 Bytes (0x0)
size : 8 bit
access : read-write
reset_value : 0x0
reset_Mask : 0x0
MB : no description available
bits : 0 - 7 (8 bit)
access : read-write
CMT Modulator Data Register Space High
address_offset : 0x8 Bytes (0x0)
size : 8 bit
access : read-write
reset_value : 0x0
reset_Mask : 0x0
SB : no description available
bits : 0 - 7 (8 bit)
access : read-write
CMT Modulator Data Register Space Low
address_offset : 0x9 Bytes (0x0)
size : 8 bit
access : read-write
reset_value : 0x0
reset_Mask : 0x0
SB : no description available
bits : 0 - 7 (8 bit)
access : read-write
CMT Primary Prescaler Register
address_offset : 0xA Bytes (0x0)
size : 8 bit
access : read-write
reset_value : 0x0
reset_Mask : 0x0
PPSDIV : Primary Prescaler Divider
bits : 0 - 3 (4 bit)
access : read-write
Enumeration:
#0000 : 0000
Bus Clock * 1
#0001 : 0001
Bus Clock * 2
#0010 : 0010
Bus Clock * 3
#0011 : 0011
Bus Clock * 4
#0100 : 0100
Bus Clock * 5
#0101 : 0101
Bus Clock * 6
#0110 : 0110
Bus Clock * 7
#0111 : 0111
Bus Clock * 8
#1000 : 1000
Bus Clock * 9
#1001 : 1001
Bus Clock * 10
#1010 : 1010
Bus Clock * 11
#1011 : 1011
Bus Clock * 12
#1100 : 1100
Bus Clock * 13
#1101 : 1101
Bus Clock * 14
#1110 : 1110
Bus Clock * 15
#1111 : 1111
Bus Clock * 16
End of enumeration elements list.
CMT Direct Memory Access
address_offset : 0xB Bytes (0x0)
size : 8 bit
access : read-write
reset_value : 0x0
reset_Mask : 0x0
DMA : DMA Enable
bits : 0 - 0 (1 bit)
access : read-write
Enumeration:
#0 : 0
DMA transfer request and done are disabled
#1 : 1
DMA transfer request and done are enabled
End of enumeration elements list.
Is something missing? Is something wrong? can you help correct it ? Please contact us at info@chipselect.org !
This website is sponsored by Embeetle, an IDE designed from scratch for embedded software developers.