\n
address_offset : 0x0 Bytes (0x0)
size : 0x18 byte (0x0)
mem_usage : registers
protection : not protected
Flash Status Register
address_offset : 0x0 Bytes (0x0)
size : 8 bit
access : read-write
reset_value : 0x0
reset_Mask : 0x0
MGSTAT0 : Memory Controller Command Completion Status Flag
bits : 0 - 0 (1 bit)
access : read-only
RESERVED : no description available
bits : 1 - 3 (3 bit)
access : read-only
FPVIOL : Flash Protection Violation Flag
bits : 4 - 4 (1 bit)
access : read-write
Enumeration:
#0 : 0
No protection violation detected
#1 : 1
Protection violation detected
End of enumeration elements list.
ACCERR : Flash Access Error Flag
bits : 5 - 5 (1 bit)
access : read-write
Enumeration:
#0 : 0
No access error detected
#1 : 1
Access error detected
End of enumeration elements list.
RDCOLERR : FTFE Read Collision Error Flag
bits : 6 - 6 (1 bit)
access : read-write
Enumeration:
#0 : 0
No collision error detected
#1 : 1
Collision error detected
End of enumeration elements list.
CCIF : Command Complete Interrupt Flag
bits : 7 - 7 (1 bit)
access : read-write
Enumeration:
#0 : 0
FTFE command or EEPROM file system operation in progress
#1 : 1
FTFE command or EEPROM file system operation has completed
End of enumeration elements list.
Flash Configuration Register
address_offset : 0x1 Bytes (0x0)
size : 8 bit
access : read-write
reset_value : 0x0
reset_Mask : 0x0
EEERDY : no description available
bits : 0 - 0 (1 bit)
access : read-only
Enumeration:
#0 : 0
For devices with FlexNVM: FlexRAM is not available for EEPROM operation.
#1 : 1
For devices with FlexNVM: FlexRAM is available for EEPROM operations where: reads from the FlexRAM return data previously written to the FlexRAM in EEPROM mode and writes launch an EEPROM operation to store the written data in the FlexRAM and EEPROM backup.
End of enumeration elements list.
RAMRDY : RAM Ready
bits : 1 - 1 (1 bit)
access : read-only
Enumeration:
#0 : 0
For devices with FlexNVM: FlexRAM is not available for traditional RAM access. For devices without FlexNVM: Programming acceleration RAM is not available.
#1 : 1
For devices with FlexNVM: FlexRAM is available as traditional RAM only; writes to the FlexRAM do not trigger EEPROM operations. For devices without FlexNVM: Programming acceleration RAM is available.
End of enumeration elements list.
PFLSH : FTFE configuration
bits : 2 - 2 (1 bit)
access : read-only
Enumeration:
#0 : 0
For devices with FlexNVM: FTFE configuration supports two logical program flash blocks and two logical FlexNVM blocks For devices with program flash only: Reserved
#1 : 1
For devices with FlexNVM: Reserved For devices with program flash only: FTFE configuration supports four logical program flash blocks
End of enumeration elements list.
SWAP : Swap
bits : 3 - 3 (1 bit)
access : read-only
Enumeration:
#0 : 0
For devices with FlexNVM: Logical program flash 0 block is located at relative address 0x0000 For devices with program flash only: Logical program flash 0/1 blocks are located at relative address 0x0000
#1 : 1
For devices with FlexNVM: Logical program flash 1 block is located at relative address 0x0000 For devices with program flash only: Logical program flash 2/3 blocks are located at relative address 0x0000
End of enumeration elements list.
ERSSUSP : Erase Suspend
bits : 4 - 4 (1 bit)
access : read-write
Enumeration:
#0 : 0
No suspend requested
#1 : 1
Suspend the current Erase Flash Sector command execution.
End of enumeration elements list.
ERSAREQ : Erase All Request
bits : 5 - 5 (1 bit)
access : read-only
Enumeration:
#0 : 0
No request or request complete
#1 : 1
Request to: run the Erase All Blocks command, verify the erased state, program the security byte in the Flash Configuration Field to the unsecure state, and release MCU security by setting the FSEC[SEC] field to the unsecure state.
End of enumeration elements list.
RDCOLLIE : Read Collision Error Interrupt Enable
bits : 6 - 6 (1 bit)
access : read-write
Enumeration:
#0 : 0
Read collision error interrupt disabled
#1 : 1
Read collision error interrupt enabled. An interrupt request is generated whenever an FTFE read collision error is detected (see the description of FSTAT[RDCOLERR]).
End of enumeration elements list.
CCIE : Command Complete Interrupt Enable
bits : 7 - 7 (1 bit)
access : read-write
Enumeration:
#0 : 0
Command complete interrupt disabled
#1 : 1
Command complete interrupt enabled. An interrupt request is generated whenever the FSTAT[CCIF] flag is set.
End of enumeration elements list.
Flash Common Command Object Registers
address_offset : 0x13 Bytes (0x0)
size : 8 bit
access : read-write
reset_value : 0x0
reset_Mask : 0x0
CCOBn : no description available
bits : 0 - 7 (8 bit)
access : read-write
EEPROM Protection Register
address_offset : 0x16 Bytes (0x0)
size : 8 bit
access : read-write
reset_value : 0x0
reset_Mask : 0x0
EPROT : EEPROM Region Protect
bits : 0 - 7 (8 bit)
access : read-write
Enumeration:
#0 : 0
For devices with program flash only: Reserved For devices with FlexNVM: EEPROM region is protected
#1 : 1
For devices with program flash only: Reserved For devices with FlexNVM: EEPROM region is not protected
End of enumeration elements list.
Data Flash Protection Register
address_offset : 0x17 Bytes (0x0)
size : 8 bit
access : read-write
reset_value : 0x0
reset_Mask : 0x0
DPROT : Data Flash Region Protect
bits : 0 - 7 (8 bit)
access : read-write
Enumeration:
#0 : 0
Data Flash region is protected
#1 : 1
Data Flash region is not protected
End of enumeration elements list.
Flash Common Command Object Registers
address_offset : 0x1A Bytes (0x0)
size : 8 bit
access : read-write
reset_value : 0x0
reset_Mask : 0x0
CCOBn : no description available
bits : 0 - 7 (8 bit)
access : read-write
Flash Security Register
address_offset : 0x2 Bytes (0x0)
size : 8 bit
access : read-only
reset_value : 0x0
reset_Mask : 0x0
SEC : Flash Security
bits : 0 - 1 (2 bit)
access : read-only
Enumeration:
#00 : 00
MCU security status is secure
#01 : 01
MCU security status is secure
#10 : 10
MCU security status is unsecure (The standard shipping condition of the FTFE is unsecure.)
#11 : 11
MCU security status is secure
End of enumeration elements list.
FSLACC : Freescale Failure Analysis Access Code
bits : 2 - 3 (2 bit)
access : read-only
Enumeration:
#00 : 00
Freescale factory access granted
#01 : 01
Freescale factory access denied
#10 : 10
Freescale factory access denied
#11 : 11
Freescale factory access granted
End of enumeration elements list.
MEEN : Mass Erase Enable Bits
bits : 4 - 5 (2 bit)
access : read-only
Enumeration:
#00 : 00
Mass erase is enabled
#01 : 01
Mass erase is enabled
#10 : 10
Mass erase is disabled
#11 : 11
Mass erase is enabled
End of enumeration elements list.
KEYEN : Backdoor Key Security Enable
bits : 6 - 7 (2 bit)
access : read-only
Enumeration:
#00 : 00
Backdoor key access disabled
#01 : 01
Backdoor key access disabled (preferred KEYEN state to disable backdoor key access)
#10 : 10
Backdoor key access enabled
#11 : 11
Backdoor key access disabled
End of enumeration elements list.
Program Flash Protection Registers
address_offset : 0x20 Bytes (0x0)
size : 8 bit
access : read-write
reset_value : 0x0
reset_Mask : 0x0
PROT : Program Flash Region Protect
bits : 0 - 7 (8 bit)
access : read-write
Enumeration:
#0 : 0
Program flash region is protected.
#1 : 1
Program flash region is not protected
End of enumeration elements list.
Flash Common Command Object Registers
address_offset : 0x22 Bytes (0x0)
size : 8 bit
access : read-write
reset_value : 0x0
reset_Mask : 0x0
CCOBn : no description available
bits : 0 - 7 (8 bit)
access : read-write
Flash Common Command Object Registers
address_offset : 0x2B Bytes (0x0)
size : 8 bit
access : read-write
reset_value : 0x0
reset_Mask : 0x0
CCOBn : no description available
bits : 0 - 7 (8 bit)
access : read-write
Flash Option Register
address_offset : 0x3 Bytes (0x0)
size : 8 bit
access : read-only
reset_value : 0x0
reset_Mask : 0x0
OPT : Nonvolatile Option
bits : 0 - 7 (8 bit)
access : read-only
Program Flash Protection Registers
address_offset : 0x31 Bytes (0x0)
size : 8 bit
access : read-write
reset_value : 0x0
reset_Mask : 0x0
PROT : Program Flash Region Protect
bits : 0 - 7 (8 bit)
access : read-write
Enumeration:
#0 : 0
Program flash region is protected.
#1 : 1
Program flash region is not protected
End of enumeration elements list.
Flash Common Command Object Registers
address_offset : 0x35 Bytes (0x0)
size : 8 bit
access : read-write
reset_value : 0x0
reset_Mask : 0x0
CCOBn : no description available
bits : 0 - 7 (8 bit)
access : read-write
Flash Common Command Object Registers
address_offset : 0x40 Bytes (0x0)
size : 8 bit
access : read-write
reset_value : 0x0
reset_Mask : 0x0
CCOBn : no description available
bits : 0 - 7 (8 bit)
access : read-write
Program Flash Protection Registers
address_offset : 0x43 Bytes (0x0)
size : 8 bit
access : read-write
reset_value : 0x0
reset_Mask : 0x0
PROT : Program Flash Region Protect
bits : 0 - 7 (8 bit)
access : read-write
Enumeration:
#0 : 0
Program flash region is protected.
#1 : 1
Program flash region is not protected
End of enumeration elements list.
Flash Common Command Object Registers
address_offset : 0x4C Bytes (0x0)
size : 8 bit
access : read-write
reset_value : 0x0
reset_Mask : 0x0
CCOBn : no description available
bits : 0 - 7 (8 bit)
access : read-write
Program Flash Protection Registers
address_offset : 0x56 Bytes (0x0)
size : 8 bit
access : read-write
reset_value : 0x0
reset_Mask : 0x0
PROT : Program Flash Region Protect
bits : 0 - 7 (8 bit)
access : read-write
Enumeration:
#0 : 0
Program flash region is protected.
#1 : 1
Program flash region is not protected
End of enumeration elements list.
Flash Common Command Object Registers
address_offset : 0x59 Bytes (0x0)
size : 8 bit
access : read-write
reset_value : 0x0
reset_Mask : 0x0
CCOBn : no description available
bits : 0 - 7 (8 bit)
access : read-write
Flash Common Command Object Registers
address_offset : 0x67 Bytes (0x0)
size : 8 bit
access : read-write
reset_value : 0x0
reset_Mask : 0x0
CCOBn : no description available
bits : 0 - 7 (8 bit)
access : read-write
Flash Common Command Object Registers
address_offset : 0x76 Bytes (0x0)
size : 8 bit
access : read-write
reset_value : 0x0
reset_Mask : 0x0
CCOBn : no description available
bits : 0 - 7 (8 bit)
access : read-write
Flash Common Command Object Registers
address_offset : 0x8 Bytes (0x0)
size : 8 bit
access : read-write
reset_value : 0x0
reset_Mask : 0x0
CCOBn : no description available
bits : 0 - 7 (8 bit)
access : read-write
Flash Common Command Object Registers
address_offset : 0xD Bytes (0x0)
size : 8 bit
access : read-write
reset_value : 0x0
reset_Mask : 0x0
CCOBn : no description available
bits : 0 - 7 (8 bit)
access : read-write
Is something missing? Is something wrong? can you help correct it ? Please contact us at info@chipselect.org !
This website is sponsored by Embeetle, an IDE designed from scratch for embedded software developers.