\n
address_offset : 0x0 Bytes (0x0)
size : 0x1 byte (0x0)
mem_usage : registers
protection : not protected
OSC Control Register
address_offset : 0x0 Bytes (0x0)
size : 8 bit
access : read-write
reset_value : 0x0
reset_Mask : 0x0
OSCINIT : OSC Initialization
bits : 0 - 0 (1 bit)
access : read-only
Enumeration:
#0 : 0
Oscillator initialization is not complete.
#1 : 1
Oscillator initialization is completed.
End of enumeration elements list.
HGO : High Gain Oscillator Select
bits : 1 - 1 (1 bit)
access : read-write
Enumeration:
#0 : 0
Low-power mode
#1 : 1
High-gain mode
End of enumeration elements list.
RANGE : Frequency Range Select
bits : 2 - 2 (1 bit)
access : read-write
Enumeration:
#0 : 0
Low frequency range of 32 kHz.
#1 : 1
High frequency range of 4-24 MHz.
End of enumeration elements list.
RESERVED : no description available
bits : 3 - 3 (1 bit)
access : read-only
OSCOS : OSC Output Select
bits : 4 - 4 (1 bit)
access : read-write
Enumeration:
#0 : 0
External clock source from EXTAL pin is selected.
#1 : 1
Oscillator clock source is selected.
End of enumeration elements list.
OSCSTEN : OSC Enable in Stop mode
bits : 5 - 5 (1 bit)
access : read-write
Enumeration:
#0 : 0
OSC clock is disabled in Stop mode.
#1 : 1
OSC clock stays enabled in Stop mode.
End of enumeration elements list.
RESERVED : no description available
bits : 6 - 6 (1 bit)
access : read-only
OSCEN : OSC Enable
bits : 7 - 7 (1 bit)
access : read-write
Enumeration:
#0 : 0
OSC module is disabled.
#1 : 1
OSC module is enabled.
End of enumeration elements list.
Is something missing? Is something wrong? can you help correct it ? Please contact us at info@chipselect.org !
This website is sponsored by Embeetle, an IDE designed from scratch for embedded software developers.