Embeetle, an IDE designed from scratch for embedded software developers.address_offset : 0x0 Bytes (0x0)
size : 0xFFC byte (0x0)
mem_usage : registers
protection : not protected
Module Control
address_offset : 0x0 Bytes (0x0)
access : read-write
reset_value : 0x0
reset_Mask : 0x0
VBUSVLDF : VBUS Valid Flag.
bits : 0 - 0 (1 bit)
access : read-only
Enumeration:
0 : NOT_SET
The current voltage on the VBUS pin is below the valid threshold.
1 : SET
The current voltage on the VBUS pin is above the valid threshold.
End of enumeration elements list.
SUSEN : Voltage Regulator Suspend Enable.
bits : 1 - 1 (1 bit)
Enumeration:
0 : DISABLED
Disable regulator suspend mode.
1 : ENABLED
Enable regulator suspend mode.
End of enumeration elements list.
BGDIS : Band Gap Disable.
bits : 5 - 5 (1 bit)
Enumeration:
0 : INACTIVE
Enable the voltage regulator band gap.
1 : ACTIVE
Disable the voltage regulator band gap.
End of enumeration elements list.
SENSEEN : VREGIN Sense Enable.
bits : 6 - 6 (1 bit)
Enumeration:
0 : DISABLED
Disable VREGIN voltage sensing.
1 : ENABLED
Enable VREGIN voltage sensing.
End of enumeration elements list.
VBUSIVLDI : VBUS Invalid Interrupt Flag.
bits : 7 - 7 (1 bit)
Enumeration:
0 : NOT_SET
The voltage on the VBUS pin has not dropped below the valid threshold.
1 : SET
The voltage on the VBUS pin dropped below the valid threshold since the last time this bit was cleared.
End of enumeration elements list.
VBUSIVLDIEN : VBUS Invalid Interrupt Enable.
bits : 8 - 8 (1 bit)
Enumeration:
0 : DISABLED
Disable the VBUS invalid interrupt.
1 : ENABLED
Enable the VBUS invalid interrupt.
End of enumeration elements list.
VREGDIS : Voltage Regulator Disable.
bits : 31 - 31 (1 bit)
Enumeration:
0 : INACTIVE
Enable the voltage regulator.
1 : ACTIVE
Disable the voltage regulator.
End of enumeration elements list.
Is something missing? Is something wrong? can you help correct it ? Please contact us at info@chipselect.org !
This website is sponsored by Embeetle, an IDE designed from scratch for embedded software developers.