\n
address_offset : 0x0 Bytes (0x0)
size : 0xFFC byte (0x0)
mem_usage : registers
protection : not protected
Oscillator Control
address_offset : 0x0 Bytes (0x0)
access : read-write
reset_value : 0x0
reset_Mask : 0x0
FREQCN : Frequency Control.
bits : 0 - 2 (3 bit)
Enumeration:
0 : RANGE0
Set the external oscillator to range 0.
1 : RANGE1
Set the external oscillator to range 1.
2 : RANGE2
Set the external oscillator to range 2.
3 : RANGE3
Set the external oscillator to range 3.
4 : RANGE4
Set the external oscillator to range 4.
5 : RANGE5
Set the external oscillator to range 5.
6 : RANGE6
Set the external oscillator to range 6.
7 : RANGE7
Set the external oscillator to range 7.
End of enumeration elements list.
OSCVLDF : Oscillator Valid Flag.
bits : 3 - 3 (1 bit)
access : read-only
Enumeration:
0 : NOT_SET
The external oscillator is unused or not yet stable.
1 : SET
The external oscillator is running and stable.
End of enumeration elements list.
OSCMD : Oscillator Mode.
bits : 4 - 6 (3 bit)
Enumeration:
0 : OFF
External oscillator off.
2 : CMOS
External CMOS clock mode.
3 : CMOSDIV2
External CMOS with divide by 2 stage.
4 : RC
RC oscillator mode with divide by 2 stage.
5 : C
C oscillator mode with divide by 2 stage.
6 : XTAL
Crystal oscillator mode.
7 : XTALDIV2
Crystal oscillator mode with divide by 2 stage.
End of enumeration elements list.
Is something missing? Is something wrong? can you help correct it ? Please contact us at info@chipselect.org !
This website is sponsored by Embeetle, an IDE designed from scratch for embedded software developers.