\n
address_offset : 0x0 Bytes (0x0)
size : 0xFFC byte (0x0)
mem_usage : registers
protection : not protected
Module Control
address_offset : 0x0 Bytes (0x0)
access : read-write
reset_value : 0x0
reset_Mask : 0x0
VBATRSTF : VBAT Reset Threshold Status Flag.
bits : 2 - 2 (1 bit)
access : read-only
Enumeration:
0 : VBAT_IS_BELOW_RESET
The VBAT voltage is below the VBAT reset threshold.
1 : VBAT_IS_ABOVE_RESET
The VBAT voltage is above the VBAT reset threshold.
End of enumeration elements list.
VBATLI : VBAT Low Interrupt Flag.
bits : 3 - 3 (1 bit)
access : read-only
Enumeration:
0 : VBAT_IS_LOW
The VBAT voltage is below the early warning threshold.
1 : VBAT_IS_OK
The VBAT voltage is above the early warning threshold.
End of enumeration elements list.
VBATHITHEN : VBAT High Threshold Enable.
bits : 4 - 4 (1 bit)
Enumeration:
0 : DISABLED
Use the standard VBAT thresholds.
1 : ENABLED
Use the high VBAT thresholds.
End of enumeration elements list.
VBATLIEN : VBAT Low Interrupt Enable.
bits : 6 - 6 (1 bit)
Enumeration:
0 : DISABLED
Disable the VBAT low interrupt.
1 : ENABLED
Enable the VBAT low interrupt.
End of enumeration elements list.
VMONEN : VBAT Supply Monitor Enable.
bits : 31 - 31 (1 bit)
Enumeration:
0 : DISABLED
Disable the VBAT supply monitor.
1 : ENABLED
Enable the VBAT supply monitor.
End of enumeration elements list.
Is something missing? Is something wrong? can you help correct it ? Please contact us at info@chipselect.org !
This website is sponsored by Embeetle, an IDE designed from scratch for embedded software developers.