\n
address_offset : 0x0 Bytes (0x0)
size : 0x400 byte (0x0)
mem_usage : registers
protection : not protected
Interrupt Enable Register
address_offset : 0x0 Bytes (0x0)
size : 32 bit
access : write-only
reset_value : 0x0
reset_Mask : 0x0
PSOK : Power Scaling OK Interrupt Enable
bits : 0 - 0 (1 bit)
access : write-only
AE : Access Error Interrupt Enable
bits : 31 - 31 (1 bit)
access : write-only
Interrupt Clear Register
address_offset : 0x10 Bytes (0x0)
size : 32 bit
access : write-only
reset_value : 0x0
reset_Mask : 0x0
PSOK : Power Scaling OK Interrupt Status Clear
bits : 0 - 0 (1 bit)
access : write-only
AE : Access Error Interrupt Status Clear
bits : 31 - 31 (1 bit)
access : write-only
Status Register
address_offset : 0x14 Bytes (0x0)
size : 32 bit
access : read-only
reset_value : 0x0
reset_Mask : 0x0
PSOK : Power Scaling OK Status
bits : 0 - 0 (1 bit)
access : read-only
Unlock Register
address_offset : 0x18 Bytes (0x0)
size : 32 bit
access : write-only
reset_value : 0x0
reset_Mask : 0x0
ADDR : Unlock Address
bits : 0 - 9 (10 bit)
access : write-only
KEY : Unlock Key
bits : 24 - 31 (8 bit)
access : write-only
Power Mode Control Register
address_offset : 0x1C Bytes (0x0)
size : 32 bit
access : read-write
reset_value : 0x0
reset_Mask : 0x0
PS : Power Scaling Configuration Value
bits : 0 - 1 (2 bit)
PSCREQ : Power Scaling Change Request
bits : 2 - 2 (1 bit)
PSCM : Power Scaling Change Mode
bits : 3 - 3 (1 bit)
BKUP : BACKUP Mode
bits : 8 - 8 (1 bit)
RET : RETENTION Mode
bits : 9 - 9 (1 bit)
SLEEP : SLEEP mode Configuration
bits : 12 - 13 (2 bit)
CK32S : 32Khz-1Khz Clock Source Selection
bits : 16 - 16 (1 bit)
FASTWKUP : Fast Wakeup
bits : 24 - 24 (1 bit)
Backup Wake up Cause Register
address_offset : 0x28 Bytes (0x0)
size : 32 bit
access : read-only
reset_value : 0x0
reset_Mask : 0x0
Backup Wake up Enable Register
address_offset : 0x2C Bytes (0x0)
size : 32 bit
access : read-write
reset_value : 0x0
reset_Mask : 0x0
Backup Pin Muxing Register
address_offset : 0x30 Bytes (0x0)
size : 32 bit
access : read-write
reset_value : 0x0
reset_Mask : 0x0
BKUPPMUX : Backup Pin Muxing
bits : 0 - 8 (9 bit)
Input Output Retention Register
address_offset : 0x34 Bytes (0x0)
size : 32 bit
access : read-write
reset_value : 0x0
reset_Mask : 0x0
RET : Retention on I/O lines after waking up from the BACKUP mode
bits : 0 - 0 (1 bit)
Interrupt Disable Register
address_offset : 0x4 Bytes (0x0)
size : 32 bit
access : write-only
reset_value : 0x0
reset_Mask : 0x0
PSOK : Power Scaling OK Interrupt Disable
bits : 0 - 0 (1 bit)
access : write-only
AE : Access Error Interrupt Disable
bits : 31 - 31 (1 bit)
access : write-only
Bypass Register
address_offset : 0x40 Bytes (0x0)
size : 32 bit
access : read-write
reset_value : 0x0
reset_Mask : 0x0
RUNPSPB : Run Mode Power Scaling Preset Bypass
bits : 0 - 0 (1 bit)
PSMPSPB : Power Save Mode Power Scaling Preset Bypass
bits : 1 - 1 (1 bit)
SEQSTN : Sequencial Startup from ULP (Active Low)
bits : 2 - 2 (1 bit)
PSBTD : Power Scaling Bias Timing Disable
bits : 3 - 3 (1 bit)
PSHFD : Power Scaling Halt Flash Until VREGOK Disable
bits : 4 - 4 (1 bit)
DLYRSTD : Delaying Reset Disable
bits : 5 - 5 (1 bit)
BIASSEN : Bias Switch Enable
bits : 6 - 6 (1 bit)
LATSEN : Latdel Switch Enable
bits : 7 - 7 (1 bit)
BOD18CONT : BOD18 in continuous mode not disabled in WAIT/RET/BACKUP modes
bits : 8 - 8 (1 bit)
POBS : Pico Uart Observability
bits : 9 - 9 (1 bit)
FFFW : Force Flash Fast Wakeup
bits : 10 - 10 (1 bit)
FBRDYEN : Flash Bias Ready Enable
bits : 11 - 11 (1 bit)
FVREFSEN : Flash Vref Switch Enable
bits : 12 - 12 (1 bit)
Factory Word Run PS Register
address_offset : 0x44 Bytes (0x0)
size : 32 bit
access : read-only
reset_value : 0x0
reset_Mask : 0x0
REGLEVEL : Regulator Voltage Level
bits : 0 - 3 (4 bit)
REGTYPE : Regulator Type
bits : 4 - 5 (2 bit)
Enumeration: REGTYPESelect
0x0 : NORMAL
None
0x1 : LP
None
0x2 : XULP
None
End of enumeration elements list.
REFTYPE : Reference Type
bits : 6 - 7 (2 bit)
Enumeration: REFTYPESelect
0x0 : BOTH
None
0x1 : BG
None
0x2 : LPBG
None
0x3 : INTERNAL
None
End of enumeration elements list.
FLASHLATDEL : Flash Latch Delay Value
bits : 8 - 12 (5 bit)
FLASHBIAS : Flash Bias Value
bits : 13 - 16 (4 bit)
FPPW : Flash Pico Power Mode
bits : 17 - 17 (1 bit)
RC115 : RC 115KHZ Calibration Value
bits : 18 - 24 (7 bit)
RCFAST : RCFAST Calibration Value
bits : 25 - 31 (7 bit)
Factory Word Power Save PS Register
address_offset : 0x48 Bytes (0x0)
size : 32 bit
access : read-only
reset_value : 0x0
reset_Mask : 0x0
WREGLEVEL : Wait mode Regulator Level
bits : 0 - 3 (4 bit)
access : read-only
WBIAS : Bias in wait mode
bits : 4 - 7 (4 bit)
access : read-only
WLATDEL : Flash Latdel in wait mode
bits : 8 - 12 (5 bit)
access : read-only
RREGLEVEL : Retention mode Regulator Level
bits : 13 - 16 (4 bit)
access : read-only
RBIAS : Bias in Retention mode
bits : 17 - 20 (4 bit)
access : read-only
RLATDEL : Flash Latdel in Retention mode
bits : 21 - 25 (5 bit)
access : read-only
BREGLEVEL : Backup mode Regulator Level
bits : 26 - 29 (4 bit)
access : read-only
POR18DIS : POR 18 Disable
bits : 30 - 30 (1 bit)
access : read-only
FWSAS : Flash Wait State Automatic Switching
bits : 31 - 31 (1 bit)
access : read-only
Interrupt Mask Register
address_offset : 0x8 Bytes (0x0)
size : 32 bit
access : read-only
reset_value : 0x0
reset_Mask : 0x0
PSOK : Power Scaling OK Interrupt Mask
bits : 0 - 0 (1 bit)
access : read-only
AE : Access Error Interrupt Mask
bits : 31 - 31 (1 bit)
access : read-only
Interrupt Status Register
address_offset : 0xC Bytes (0x0)
size : 32 bit
access : read-only
reset_value : 0x0
reset_Mask : 0x0
PSOK : Power Scaling OK Interrupt Status
bits : 0 - 0 (1 bit)
access : read-only
AE : Access Error Interrupt Status
bits : 31 - 31 (1 bit)
access : read-only
Version Register
address_offset : 0xFC Bytes (0x0)
size : 32 bit
access : read-only
reset_value : 0x0
reset_Mask : 0x0
VERSION : Version Number
bits : 0 - 11 (12 bit)
access : read-only
VARIANT : Variant Number
bits : 16 - 19 (4 bit)
access : read-only
Is something missing? Is something wrong? can you help correct it ? Please contact us at info@chipselect.org !
This website is sponsored by Embeetle, an IDE designed from scratch for embedded software developers.