\n

SYSC

Peripheral Memory Blocks

address_offset : 0x0 Bytes (0x0)
size : 0x1000 byte (0x0)
mem_usage : registers
protection : not protected

Registers

CR

SR

MR


CR

Control Register
address_offset : 0x0 Bytes (0x0)
size : 32 bit
access : write-only
reset_value : 0x0
reset_Mask : 0x0

CR CR write-only 0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 Resets to Resets to 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 PROCRST KEY

PROCRST : Processor Reset
bits : 0 - 0 (1 bit)
access : write-only

KEY : Write Access Password
bits : 24 - 31 (8 bit)
access : write-only

Enumeration:

0xA5 : PASSWD

Writing any other value in this field aborts the write operation.Always reads as 0.

End of enumeration elements list.


SR

Status Register
address_offset : 0x4 Bytes (0x0)
size : 32 bit
access : read-only
reset_value : 0x0
reset_Mask : 0x0

SR SR read-only 0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 Resets to Resets to 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 URSTS RSTTYP NRSTL SRCMP

URSTS : User Reset Status
bits : 0 - 0 (1 bit)
access : read-only

RSTTYP : Reset Type
bits : 8 - 10 (3 bit)
access : read-only

Enumeration:

0x0 : GENERAL_RST

Both VDDCORE and VDDBU rising

0x1 : WKUP_RST

VDDCORE rising

0x2 : WDT_RST

Watchdog fault occurred

0x3 : SOFT_RST

Processor reset required by the software

0x4 : USER_RST

NRST pin detected low

End of enumeration elements list.

NRSTL : NRST Pin Level
bits : 16 - 16 (1 bit)
access : read-only

SRCMP : Software Reset Command in Progress
bits : 17 - 17 (1 bit)
access : read-only


MR

Mode Register
address_offset : 0x8 Bytes (0x0)
size : 32 bit
access : read-write
reset_value : 0x0
reset_Mask : 0x0

MR MR read-write 0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 Resets to Resets to 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 URSTEN URSTIEN KEY

URSTEN : User Reset Enable
bits : 0 - 0 (1 bit)
access : read-write

URSTIEN : User Reset Interrupt Enable
bits : 4 - 4 (1 bit)
access : read-write

KEY : Write Access Password
bits : 24 - 31 (8 bit)
access : read-write

Enumeration:

0xA5 : PASSWD

Writing any other value in this field aborts the write operation.Always reads as 0.

End of enumeration elements list.



Is something missing? Is something wrong? can you help correct it ? Please contact us at info@chipselect.org !

This website is sponsored by EmbeetleEmbeetle, an IDE designed from scratch for embedded software developers.