Embeetle, an IDE designed from scratch for embedded software developers.address_offset : 0x0 Bytes (0x0)
size : 0x1 byte (0x0)
mem_usage : registers
protection : not protected
OSC Control Register
address_offset : 0x0 Bytes (0x0)
size : 8 bit
access : read-write
reset_value : 0x0
reset_Mask : 0x0
SC16P : Oscillator 16 pF Capacitor Load Configure
bits : 0 - 0 (1 bit)
access : read-write
Enumeration:
#0 : 0
Disable the selection.
#1 : 1
Add 16 pF capacitor to the oscillator load.
End of enumeration elements list.
SC8P : Oscillator 8 pF Capacitor Load Configure
bits : 1 - 1 (1 bit)
access : read-write
Enumeration:
#0 : 0
Disable the selection.
#1 : 1
Add 8 pF capacitor to the oscillator load.
End of enumeration elements list.
SC4P : Oscillator 4 pF Capacitor Load Configure
bits : 2 - 2 (1 bit)
access : read-write
Enumeration:
#0 : 0
Disable the selection.
#1 : 1
Add 4 pF capacitor to the oscillator load.
End of enumeration elements list.
SC2P : Oscillator 2 pF Capacitor Load Configure
bits : 3 - 3 (1 bit)
access : read-write
Enumeration:
#0 : 0
Disable the selection.
#1 : 1
Add 2 pF capacitor to the oscillator load.
End of enumeration elements list.
RESERVED : no description available
bits : 4 - 4 (1 bit)
access : read-only
EREFSTEN : External Reference Stop Enable
bits : 5 - 5 (1 bit)
access : read-write
Enumeration:
#0 : 0
External reference clock is disabled in Stop mode.
#1 : 1
External reference clock stays enabled in Stop mode if ERCLKEN is set before entering Stop mode.
End of enumeration elements list.
RESERVED : no description available
bits : 6 - 6 (1 bit)
access : read-only
ERCLKEN : External Reference Enable
bits : 7 - 7 (1 bit)
access : read-write
Enumeration:
#0 : 0
External reference clock is inactive.
#1 : 1
External reference clock is enabled.
End of enumeration elements list.
Is something missing? Is something wrong? can you help correct it ? Please contact us at info@chipselect.org !
This website is sponsored by Embeetle, an IDE designed from scratch for embedded software developers.