\n
address_offset : 0x0 Bytes (0x0)
size : 0x10 byte (0x0)
mem_usage : registers
protection : not protected
OSC_HP Status Register
address_offset : 0x0 Bytes (0x0)
size : 32 bit
access : read-write
reset_value : 0x0
reset_Mask : 0x0
X1D : XTAL1 Data Value
bits : 0 - -1 (0 bit)
access : read-only
OSC_HP Control Register
address_offset : 0x4 Bytes (0x0)
size : 32 bit
access : read-write
reset_value : 0x0
reset_Mask : 0x0
X1DEN : XTAL1 Data Enable
bits : 0 - -1 (0 bit)
access : read-write
Enumeration:
#0 : value1
Bit X1D is not updated
#1 : value2
Bit X1D can be updated
End of enumeration elements list.
SHBY : Shaper Bypass
bits : 1 - 0 (0 bit)
access : read-write
Enumeration:
#0 : value1
The shaper is not bypassed
#1 : value2
The shaper is bypassed
End of enumeration elements list.
MODE : Oscillator Mode
bits : 4 - 4 (1 bit)
access : read-write
Enumeration:
#00 : value1
External Crystal Mode and External Input Clock Mode. The oscillator Power-Saving Mode is not entered.
#01 : value2
OSC is disabled. The oscillator Power-Saving Mode is not entered.
#10 : value3
External Input Clock Mode and the oscillator Power-Saving Mode is entered
#11 : value4
OSC is disabled. The oscillator Power-Saving Mode is entered.
End of enumeration elements list.
OSCVAL : OSC Frequency Value
bits : 16 - 18 (3 bit)
access : read-write
Clock Calibration Constant Register
address_offset : 0xC Bytes (0x0)
size : 32 bit
access : read-write
reset_value : 0x0
reset_Mask : 0x0
CALIBCONST : Clock Calibration Constant Value
bits : 0 - 2 (3 bit)
access : read-write
Is something missing? Is something wrong? can you help correct it ? Please contact us at info@chipselect.org !
This website is sponsored by Embeetle, an IDE designed from scratch for embedded software developers.