\n
address_offset : 0x0 Bytes (0x0)
size : 0x1 byte (0x0)
mem_usage : registers
protection : not protected
address_offset : 0x2 Bytes (0x0)
size : 0x4 byte (0x0)
mem_usage : registers
protection : not protected
DOC Control Register
address_offset : 0x0 Bytes (0x0)
size : 8 bit
access : read-write
reset_value : 0x0
reset_Mask : 0x0
OMS : Operating Mode Select
bits : 0 - 0 (1 bit)
access : read-write
Enumeration:
#00 : 00
Data comparison mode
#01 : 01
Data addition mode
#10 : 10
Data subtraction mode
#11 : 11
Setting prohibited
End of enumeration elements list.
DCSEL : Detection Condition Select
bits : 2 - 1 (0 bit)
access : read-write
Enumeration:
#0 : 0
DOPCF is set when data mismatch is detected.
#1 : 1
DOPCF is set when data match is detected.
End of enumeration elements list.
DOPCF : Data Operation Circuit Flag
bits : 5 - 4 (0 bit)
access : read-only
DOPCFCL : DOPCF Clear
bits : 6 - 5 (0 bit)
access : read-write
Enumeration:
#0 : 0
Maintains the DOPCF flag state.
#1 : 1
Clears the DOPCF flag.
End of enumeration elements list.
DOC Data Input Register
address_offset : 0x2 Bytes (0x0)
size : 16 bit
access : read-write
reset_value : 0x0
reset_Mask : 0x0
DODIR : 16-bit read-write register in which 16-bit data for use in the operations are stored.
bits : 0 - 14 (15 bit)
access : read-write
DOC Data Setting Register
address_offset : 0x4 Bytes (0x0)
size : 16 bit
access : read-write
reset_value : 0x0
reset_Mask : 0x0
DODSR : This register stores 16-bit data for use as a reference in data comparison mode. This register also stores the results of operations in data addition and data subtraction modes.
bits : 0 - 14 (15 bit)
access : read-write
Is something missing? Is something wrong? can you help correct it ? Please contact us at info@chipselect.org !
This website is sponsored by Embeetle, an IDE designed from scratch for embedded software developers.