\n
address_offset : 0x0 Bytes (0x0)
size : 0x400 byte (0x0)
mem_usage : registers
protection : not protected
Control Register
address_offset : 0x0 Bytes (0x0)
size : 32 bit
access : read-write
reset_value : 0x0
reset_Mask : 0x0
EN : Current DAC Enable
bits : 0 - 0 (1 bit)
access : read-write
CURSINK : Current Sink Enable
bits : 1 - 1 (1 bit)
access : read-write
MINOUTTRANS : Minimum Output Transition Enable
bits : 2 - 2 (1 bit)
access : read-write
OUTEN : Output Enable
bits : 3 - 3 (1 bit)
access : read-write
OUTMODE : Output Modes
bits : 4 - 4 (1 bit)
access : read-write
OUTENPRS : PRS Controlled Output Enable
bits : 18 - 18 (1 bit)
access : read-write
PRSSEL : IDAC Output PRS channnel Select
bits : 20 - 21 (2 bit)
access : read-write
Enumeration:
0x00000000 : PRSCH0
PRS Channel 0 selected.
0x00000001 : PRSCH1
PRS Channel 1 selected.
0x00000002 : PRSCH2
PRS Channel 2 selected.
0x00000003 : PRSCH3
PRS Channel 3 selected.
End of enumeration elements list.
Current Programming Register
address_offset : 0x4 Bytes (0x0)
size : 32 bit
access : read-write
reset_value : 0x0
reset_Mask : 0x0
RANGESEL : Current Range Select
bits : 0 - 1 (2 bit)
access : read-write
Enumeration:
0x00000000 : RANGE0
Current range set to 0 - 1.6 uA.
0x00000001 : RANGE1
Current range set to 1.6 - 4.7 uA.
0x00000002 : RANGE2
Current range set to 0.5 - 16 uA.
0x00000003 : RANGE3
Current range set to 2 - 64 uA.
End of enumeration elements list.
STEPSEL : Current Step Size Select
bits : 8 - 12 (5 bit)
access : read-write
Calibration Register
address_offset : 0x8 Bytes (0x0)
size : 32 bit
access : read-write
reset_value : 0x0
reset_Mask : 0x0
TUNING : Tune the current to given accuracy
bits : 0 - 6 (7 bit)
access : read-write
Duty Cycle Configauration Register
address_offset : 0xC Bytes (0x0)
size : 32 bit
access : read-write
reset_value : 0x0
reset_Mask : 0x0
DUTYCYCLEEN : Duty Cycle Enable.
bits : 0 - 0 (1 bit)
access : read-write
EM2DUTYCYCLEDIS : EM2/EM3 Duty Cycle Disable.
bits : 1 - 1 (1 bit)
access : read-write
Is something missing? Is something wrong? can you help correct it ? Please contact us at info@chipselect.org !
This website is sponsored by Embeetle, an IDE designed from scratch for embedded software developers.