\n
address_offset : 0x0 Bytes (0x0)
size : 0x10 byte (0x0)
mem_usage : registers
protection :
Control and Status Register
address_offset : 0x0 Bytes (0x0)
size : 32 bit
access : read-write
reset_value : 0x0
reset_Mask : 0x0
ENABLE : Enables the counter
bits : 0 - 0 (1 bit)
Enumeration: ENABLESelect
0 : VALUE_0
counter disabled
1 : VALUE_1
counter enabled
End of enumeration elements list.
TICKINT : Enables SysTick exception request
bits : 1 - 1 (1 bit)
Enumeration: TICKINTSelect
0 : VALUE_0
counting down to 0 does not assert the SysTick exception request
1 : VALUE_1
counting down to 0 asserts the SysTick exception request
End of enumeration elements list.
CLKSOURCE : Indicates the clock source
bits : 2 - 2 (1 bit)
Enumeration: CLKSOURCESelect
0 : VALUE_0
external clock
1 : VALUE_1
processor clock
End of enumeration elements list.
COUNTFLAG : Returns 1 if timer counted to 0 since last time this was read
bits : 16 - 16 (1 bit)
Reload Value Register
address_offset : 0x4 Bytes (0x0)
size : 32 bit
access : read-write
reset_value : 0x0
reset_Mask : 0x0
RELOAD : Value to load into the SysTick Current Value Register when the counter reaches 0
bits : 0 - 23 (24 bit)
Current Value Register
address_offset : 0x8 Bytes (0x0)
size : 32 bit
access : read-write
reset_value : 0x0
reset_Mask : 0x0
CURRENT : Current value at the time the register is accessed
bits : 0 - 23 (24 bit)
Calibration Value Register
address_offset : 0xC Bytes (0x0)
size : 32 bit
access : read-only
reset_value : 0x0
reset_Mask : 0x0
TENMS : Reload value to use for 10ms timing
bits : 0 - 23 (24 bit)
SKEW : Indicates whether the TENMS value is exact
bits : 30 - 30 (1 bit)
Enumeration: SKEWSelect
0 : VALUE_0
10ms calibration value is exact
1 : VALUE_1
10ms calibration value is inexact, because of the clock frequency
End of enumeration elements list.
NOREF : Indicates whether the device provides a reference clock to the processor
bits : 31 - 31 (1 bit)
Enumeration: NOREFSelect
0 : VALUE_0
The reference clock is provided
1 : VALUE_1
The reference clock is not provided
End of enumeration elements list.
Is something missing? Is something wrong? can you help correct it ? Please contact us at info@chipselect.org !
This website is sponsored by Embeetle, an IDE designed from scratch for embedded software developers.