\n
address_offset : 0x0 Bytes (0x0)
size : 0x8 byte (0x0)
mem_usage : registers
protection :
Configuration register foe GPIO timestamp
address_offset : 0x0 Bytes (0x0)
size : 32 bit
access : read-write
reset_value : 0x0
ENABLE_GPIO_TIMESTAMPING : Enable GPIO time stamping Feature.
bits : 0 - 0 (1 bit)
access : read-write
Enumeration:
0 : disable
Disable GPIO time stamping Feature.
1 : enable
Enable GPIO time stamping Feature.
End of enumeration elements list.
TIMESTAMPING_ON_GPIO0 : Enable GPIO time stamping on GPIO0
bits : 1 - 2 (2 bit)
access : read-write
Enumeration:
0 : disable
Disable GPIO time stamping on GPIO0
1 : enable
Enable GPIO time stamping on GPIO0
End of enumeration elements list.
TIMESTAMPING_ON_GPIO1 : Enable GPIO time stamping on GPIO1
bits : 2 - 4 (3 bit)
access : read-write
Enumeration:
0 : disable
Disable GPIO time stamping on GPIO1
1 : enable
Enable GPIO time stamping on GPIO1
End of enumeration elements list.
TIMESTAMPING_ON_GPIO2 : Enable GPIO time stamping on GPIO2
bits : 3 - 6 (4 bit)
access : read-write
Enumeration:
0 : disable
Disable GPIO time stamping on GPIO2
1 : enable
Enable GPIO time stamping on GPIO2
End of enumeration elements list.
TIMESTAMPING_ON_GPIO3 : Enable GPIO time stamping on GPIO3
bits : 4 - 8 (5 bit)
access : read-write
Enumeration:
0 : disable
Disable GPIO time stamping on GPIO3
1 : enable
Enable GPIO time stamping on GPIO3
End of enumeration elements list.
TIMESTAMPING_ON_GPIO4 : Enable GPIO time stamping on GPIO4
bits : 5 - 10 (6 bit)
access : read-write
Enumeration:
0 : disable
Disable GPIO time stamping on GPIO4
1 : enable
Enable GPIO time stamping on GPIO4
End of enumeration elements list.
RESERVED1 : It is recommended to write these bits to 0.
bits : 6 - 36 (31 bit)
access : read-write
TIMESTAMPING_DONE : This signal indicated Timestamp of GPIO is ready for reading.
bits : 31 - 62 (32 bit)
access : read-only
GPIO timestamp read register
address_offset : 0x4 Bytes (0x0)
size : 32 bit
access : read-only
reset_value : 0x0
GPIO_EVENT_COUNT_FULL : Counter value indicating the duration from GPIO going high to first Sleep clock
bits : 0 - 10 (11 bit)
access : read-only
RESERVED1 : It is recommended to write these bits to 0.
bits : 11 - 26 (16 bit)
access : read-only
GPIO_EVENT_COUNT_PARTIAL : Counter value indicating number for 32MHz clock present in 1 Sleep clock
bits : 16 - 42 (27 bit)
access : read-only
RESERVED2 : It is recommended to write these bits to 0.
bits : 27 - 58 (32 bit)
access : read-only
Is something missing? Is something wrong? can you help correct it ? Please contact us at info@chipselect.org !
This website is sponsored by Embeetle, an IDE designed from scratch for embedded software developers.