\n
address_offset : 0x0 Bytes (0x0)
size : 0x8 byte (0x0)
mem_usage : registers
protection :
Select clock for oscillator calibration
address_offset : 0x0 Bytes (0x0)
size : 16 bit
access : read-write
reset_value : 0x0
reset_Mask : 0x0
REF_CLK_SEL : Select clock input for calibration: 0x0 : RC32K oscillator 0x1 : RC16M oscillator 0x2 : XTAL32K oscillator 0x3 : RCX oscillator
bits : 0 - 1 (2 bit)
access : read-write
REF_CAL_START : Writing a '1' starts a calibration. This bit is cleared when calibration is finished, and CLK_REF_VAL is ready.
bits : 2 - 4 (3 bit)
access : read-write
Count value for oscillator calibration
address_offset : 0x2 Bytes (0x0)
size : 16 bit
access : read-write
reset_value : 0x0
reset_Mask : 0x0
REF_CNT_VAL : Indicates the calibration time, with a decrement counter to 1.
bits : 0 - 15 (16 bit)
access : read-write
XTAL16M reference cycles, lower 16 bits
address_offset : 0x4 Bytes (0x0)
size : 16 bit
access : read-write
reset_value : 0x0
reset_Mask : 0x0
XTAL_CNT_VAL : Returns the lower 16 bits of XTAL16 clock cycles during the calibration time, defined with REF_CNT_VAL
bits : 0 - 15 (16 bit)
access : read-only
XTAL16M reference cycles, upper 16 bits
address_offset : 0x6 Bytes (0x0)
size : 16 bit
access : read-write
reset_value : 0x0
reset_Mask : 0x0
XTAL_CNT_VAL : Returns the upper 16 bits of XTAL16 clock cycles during the calibration time, defined with REF_CNT_VAL
bits : 0 - 15 (16 bit)
access : read-only
Is something missing? Is something wrong? can you help correct it ? Please contact us at info@chipselect.org !
This website is sponsored by Embeetle, an IDE designed from scratch for embedded software developers.