Embeetle, an IDE designed from scratch for embedded software developers.address_offset : 0x0 Bytes (0x0)
size : 0x1 byte (0x0)
mem_usage : registers
protection :
address_offset : 0x4 Bytes (0x0)
size : 0x1 byte (0x0)
mem_usage : registers
protection :
address_offset : 0x8 Bytes (0x0)
size : 0x1 byte (0x0)
mem_usage : registers
protection :
address_offset : 0xC Bytes (0x0)
size : 0x1 byte (0x0)
mem_usage : registers
protection :
address_offset : 0x10 Bytes (0x0)
size : 0x1 byte (0x0)
mem_usage : registers
protection :
Comparator Control Register
address_offset : 0x0 Bytes (0x0)
size : 8 bit
access : read-write
reset_value : 0x0
reset_Mask : 0x0
CINV : Comparator output polarity selection
bits : 0 - -1 (0 bit)
access : read-write
Enumeration:
#0 : 0
Comparator output not inverted
#1 : 1
Comparator output inverted
End of enumeration elements list.
COE : Comparator output enable
bits : 1 - 0 (0 bit)
access : read-write
Enumeration:
#0 : 0
Comparator output disabled (the output signal is low level).
#1 : 1
Comparator output enabled
End of enumeration elements list.
CSTEN : Interrupt Select
bits : 2 - 1 (0 bit)
access : read-write
Enumeration:
#0 : 0
Output via the Edge selector
#1 : 1
Direct output
End of enumeration elements list.
CEG : Selection of valid edge (Edge selector)
bits : 3 - 3 (1 bit)
access : read-write
Enumeration:
#00 : 00
No edge selection.
#01 : 01
Rising edge selection.
#10 : 10
Falling edge selection
#11 : 11
Both-edge selection
End of enumeration elements list.
CDFS : Noise filter selection
bits : 5 - 5 (1 bit)
access : read-write
Enumeration:
#00 : 00
Noise filter not used.
#01 : 01
Noise filter sampling frequency is 2^3/PCLKB.
#10 : 10
Noise filter sampling frequency is 2^4/PCLKB.
#11 : 11
Noise filter sampling frequency is 2^5/PCLKB.
End of enumeration elements list.
HCMPON : Comparator operation control
bits : 7 - 6 (0 bit)
access : read-write
Enumeration:
#0 : 0
Operation stopped (the comparator outputs a low-level signal)
#1 : 1
Operation enabled (input to the comparator pins is enabled
End of enumeration elements list.
Comparator Output Control Register
address_offset : 0x10 Bytes (0x0)
size : 8 bit
access : read-write
reset_value : 0x0
reset_Mask : 0x0
CPOE : Comparator output selection
bits : 0 - -1 (0 bit)
access : read-write
Enumeration:
#0 : 0
VCOUT pin output of the comparator is disabled (the output signal is low level).
#1 : 1
VCOUT pin output of the comparator is enabled
End of enumeration elements list.
VREFEN : Internal Vref enable
bits : 7 - 6 (0 bit)
access : read-write
Enumeration:
#0 : 0
Internal Vref disable
#1 : 1
Internal Vref enable
End of enumeration elements list.
Comparator Input Select Register
address_offset : 0x4 Bytes (0x0)
size : 8 bit
access : read-write
reset_value : 0x0
reset_Mask : 0x0
CMPSEL : Comparator input selection
bits : 0 - 2 (3 bit)
access : read-write
Enumeration:
#0000 : 0000
No input
#0001 : 0001
IVCMP0 selected
#0010 : 0010
IVCMP1 selected
#0100 : 0100
IVCMP2 selected
#1000 : 1000
IVCMP3 selected
: others
Setting prohibited
End of enumeration elements list.
Comparator Reference Voltage Select Register
address_offset : 0x8 Bytes (0x0)
size : 8 bit
access : read-write
reset_value : 0x0
reset_Mask : 0x0
CRVS : Reference voltage selection
bits : 0 - 2 (3 bit)
access : read-write
Enumeration:
#0000 : 0000
No reference voltage
#0001 : 0001
IVREF0 selected
#0010 : 0010
IVREF1 selected
#0100 : 0100
IVREF2 selected
#1000 : 1000
IVREF3 selected
: others
Setting prohibited
End of enumeration elements list.
Comparator Output Monitor Register
address_offset : 0xC Bytes (0x0)
size : 8 bit
access : read-only
reset_value : 0x0
reset_Mask : 0x0
CMPMON : Comparator output monitor
bits : 0 - -1 (0 bit)
access : read-only
Enumeration:
#0 : 0
Comparator output Low
#1 : 1
Comparator output High
End of enumeration elements list.
Is something missing? Is something wrong? can you help correct it ? Please contact us at info@chipselect.org !
This website is sponsored by Embeetle, an IDE designed from scratch for embedded software developers.