\n
address_offset : 0x0 Bytes (0x0)
size : 0x20 byte (0x0)
mem_usage : registers
protection :
I2C Config Register
address_offset : 0x0 Bytes (0x0)
size : 32 bit
access : read-write
reset_value : 0x0
reset_Mask : 0x0
H1M : Enable SysTick Timer
bits : 0 - 0 (1 bit)
access : read-write
AA : Generate Tick Interrupt
bits : 2 - 2 (1 bit)
access : read-write
SI : Source to count from
bits : 3 - 3 (1 bit)
access : read-write
STO : SysTick counted to zero
bits : 4 - 4 (1 bit)
access : read-write
STA : SysTick counted to zero
bits : 5 - 5 (1 bit)
access : read-write
ENS : SysTick counted to zero
bits : 6 - 6 (1 bit)
access : read-write
I2C Baund Count Enable
address_offset : 0x10 Bytes (0x0)
size : 32 bit
access : read-write
reset_value : 0x0
reset_Mask : 0x0
TME : Reload value to use for 10ms timing
bits : 0 - 0 (1 bit)
access : read-write
Baud Control Register
address_offset : 0x14 Bytes (0x0)
size : 32 bit
access : read-write
reset_value : 0x0
reset_Mask : 0x0
TM : Reload value to use for 10ms timing
bits : 0 - 7 (8 bit)
access : read-only
Data
address_offset : 0x4 Bytes (0x0)
size : 32 bit
access : read-write
reset_value : 0x0
reset_Mask : 0x0
DAT : Value to auto reload SysTick after reaching zero
bits : 0 - 7 (8 bit)
access : read-write
I2C Address Register
address_offset : 0x8 Bytes (0x0)
size : 32 bit
access : read-write
reset_value : 0x0
reset_Mask : 0x0
GC : Current value
bits : 0 - 0 (1 bit)
access : read-write
I2CADR : Current value
bits : 1 - 7 (7 bit)
access : read-write
I2C Status register
address_offset : 0xC Bytes (0x0)
size : 32 bit
access : read-write
reset_value : 0x0
reset_Mask : 0x0
I2CSTA : Reload value to use for 10ms timing
bits : 0 - 7 (8 bit)
access : read-write
Is something missing? Is something wrong? can you help correct it ? Please contact us at info@chipselect.org !
This website is sponsored by Embeetle, an IDE designed from scratch for embedded software developers.