Embeetle, an IDE designed from scratch for embedded software developers.address_offset : 0x0 Bytes (0x0)
size : 0x400 byte (0x0)
mem_usage : registers
protection :
Register 0.
address_offset : 0x0 Bytes (0x0)
size : -1 bit
access : read-write
reset_value : 0x0
reset_Mask : 0x0
ERFO_RANGE_SEL : 14MHz-32MHz ERFO Frequency Range Select.
bits : 0 - 2 (3 bit)
KEYWIPE_SYS : KEYWIPE_SYS.
bits : 8 - 8 (1 bit)
I2C0_SDA_FILTER_EN : I2C0 SDA Glitch Filter Enable.
bits : 20 - 20 (1 bit)
Enumeration:
0 : dis
Filter disabled.
1 : en
Filter enabled.
End of enumeration elements list.
I2C0_SCL_FILTER_EN : I2C0 SCL Glitch Filter Enable.
bits : 21 - 21 (1 bit)
I2C1_SDA_FILTER_EN : I2C1 SDA Glitch Filter Enable.
bits : 22 - 22 (1 bit)
I2C1_SCL_FILTER_EN : I2C1 SCL Glitch Filter Enable.
bits : 23 - 23 (1 bit)
I2C2_SDA_FILTER_EN : I2C2 SDA Glitch Filter Enable.
bits : 24 - 24 (1 bit)
I2C2_SCL_FILTER_EN : I2C2 SCL Glitch Filter Enable.
bits : 25 - 25 (1 bit)
Register 4.
address_offset : 0x10 Bytes (0x0)
size : -1 bit
access : read-only
reset_value : 0x0
reset_Mask : 0x0
GAIN : Unsigned gain for temp sensor normalization
bits : 0 - 11 (12 bit)
Register 5.
address_offset : 0x14 Bytes (0x0)
size : -1 bit
access : read-only
reset_value : 0x0
reset_Mask : 0x0
OFFSET : Signed offset for temp sensor correction
bits : 0 - 31 (32 bit)
Register 1.
address_offset : 0x4 Bytes (0x0)
size : -1 bit
access : read-write
reset_value : 0x0
reset_Mask : 0x0
SEL : Auto-calibration Enable.
bits : 0 - 0 (1 bit)
Enumeration:
0 : dis
Disabled.
1 : en
Enabled.
End of enumeration elements list.
EN : Autocalibration Run.
bits : 1 - 1 (1 bit)
Enumeration:
0 : not
Not Running.
1 : run
Running.
End of enumeration elements list.
LOAD : Load Trim.
bits : 2 - 2 (1 bit)
INVERT : Invert Gain.
bits : 3 - 3 (1 bit)
Enumeration:
0 : not
do Not invert trim step.
1 : invert
Invert trim step.
End of enumeration elements list.
ATOMIC : Atomic mode.
bits : 4 - 4 (1 bit)
Enumeration:
0 : not
Not Running.
1 : run
Running.
End of enumeration elements list.
GAIN : MU value.
bits : 8 - 19 (12 bit)
TRIM : 150MHz HFIO Auto Calibration Trim
bits : 23 - 31 (9 bit)
Register 2.
address_offset : 0x8 Bytes (0x0)
size : -1 bit
access : read-write
reset_value : 0x0
reset_Mask : 0x0
INITIAL : 100MHz IPO Trim Automatic Calibration Initial Trim.
bits : 0 - 8 (9 bit)
Register 3.
address_offset : 0xC Bytes (0x0)
size : -1 bit
access : read-write
reset_value : 0x0
reset_Mask : 0x0
RUNTIME : 100MHz IPO Trim Automatic Calibration Run Time.
bits : 0 - 7 (8 bit)
DIV : 100MHz IPO Trim Automatic Calibration Divide Factor.
bits : 8 - 20 (13 bit)
Is something missing? Is something wrong? can you help correct it ? Please contact us at info@chipselect.org !
This website is sponsored by Embeetle, an IDE designed from scratch for embedded software developers.