\n
address_offset : 0x0 Bytes (0x0)
size : 0x400 byte (0x0)
mem_usage : registers
protection : not protected
power control register
address_offset : 0x0 Bytes (0x0)
size : 32 bit
access : read-write
reset_value : 0x0
reset_Mask : 0x0
LPDS : Low-power deep sleep
bits : 0 - 0 (1 bit)
PDDS : Power down deepsleep
bits : 1 - 1 (1 bit)
CWUF : Clear wakeup flag
bits : 2 - 2 (1 bit)
CSBF : Clear standby flag
bits : 3 - 3 (1 bit)
PVDE : Power voltage detector enable
bits : 4 - 4 (1 bit)
PLS : PVD level selection
bits : 5 - 7 (3 bit)
DBP : Disable backup domain write protection
bits : 8 - 8 (1 bit)
FPDS : Flash power down in Stop mode
bits : 9 - 9 (1 bit)
LPLVDS : Low-Power Regulator Low Voltage in deepsleep
bits : 10 - 10 (1 bit)
MRLVDS : Main regulator low voltage in deepsleep mode
bits : 11 - 11 (1 bit)
ADCDC1 : ADCDC1
bits : 13 - 13 (1 bit)
VOS : Regulator voltage scaling output selection
bits : 14 - 15 (2 bit)
ODEN : Over-drive enable
bits : 16 - 16 (1 bit)
ODSWEN : Over-drive switching enabled
bits : 17 - 17 (1 bit)
UDEN : Under-drive enable in stop mode
bits : 18 - 19 (2 bit)
FMSSR : Flash Memory Stop while System Run
bits : 20 - 20 (1 bit)
FISSR : Flash Interface Stop while System Run
bits : 21 - 21 (1 bit)
power control/status register
address_offset : 0x4 Bytes (0x0)
size : 32 bit
access : read-write
reset_value : 0x0
reset_Mask : 0x0
WUF : Wakeup flag
bits : 0 - 0 (1 bit)
access : read-only
SBF : Standby flag
bits : 1 - 1 (1 bit)
access : read-only
PVDO : PVD output
bits : 2 - 2 (1 bit)
access : read-only
BRR : Backup regulator ready
bits : 3 - 3 (1 bit)
access : read-only
EWUP2 : Enable WKUP2 pin
bits : 7 - 7 (1 bit)
access : read-write
EWUP : Enable WKUP pin
bits : 8 - 8 (1 bit)
access : read-write
BRE : Backup regulator enable
bits : 9 - 9 (1 bit)
access : read-write
VOSRDY : Regulator voltage scaling output selection ready bit
bits : 14 - 14 (1 bit)
access : read-only
ODRDY : Over-drive mode ready
bits : 16 - 16 (1 bit)
access : read-only
ODSWRDY : Over-drive mode switching ready
bits : 17 - 17 (1 bit)
access : read-only
UDRDY : Under-drive ready flag
bits : 18 - 19 (2 bit)
access : read-write
Is something missing? Is something wrong? can you help correct it ? Please contact us at info@chipselect.org !
This website is sponsored by Embeetle, an IDE designed from scratch for embedded software developers.