\n
address_offset : 0x0 Bytes (0x0)
size : 0x400 byte (0x0)
mem_usage : registers
protection : not protected
comparator control and status register
address_offset : 0x0 Bytes (0x0)
size : 32 bit
access : read-write
reset_value : 0x0
reset_Mask : 0x0
PU10K : 10 kO pull-up resistor
bits : 0 - 0 (1 bit)
access : read-write
PU400K : 400 kO pull-up resistor
bits : 1 - 1 (1 bit)
access : read-write
PD10K : 10 kO pull-down resistor
bits : 2 - 2 (1 bit)
access : read-write
PD400K : 400 kO pull-down resistor
bits : 3 - 3 (1 bit)
access : read-write
CMP1EN : Comparator 1 enable
bits : 4 - 4 (1 bit)
access : read-write
SW1 : SW1 analog switch enable
bits : 5 - 5 (1 bit)
access : read-write
CMP1OUT : Comparator 1 output
bits : 7 - 7 (1 bit)
access : read-only
SPEED : Comparator 2 speed mode
bits : 12 - 12 (1 bit)
access : read-write
CMP2OUT : Comparator 2 output
bits : 13 - 13 (1 bit)
access : read-only
VREFOUTEN : VREFINT output enable
bits : 16 - 16 (1 bit)
access : read-write
WNDWE : Window mode enable
bits : 17 - 17 (1 bit)
access : read-write
INSEL : Inverted input selection
bits : 18 - 20 (3 bit)
access : read-write
OUTSEL : Comparator 2 output selection
bits : 21 - 23 (3 bit)
access : read-write
FCH3 : Select GPIO port PA3 as fast ADC input channel CH3.
bits : 26 - 26 (1 bit)
access : read-write
FCH8 : Select GPIO port PB0 as fast ADC input channel CH8.
bits : 27 - 27 (1 bit)
access : read-write
RCH13 : Select GPIO port PC3 as re-routed ADC input channel CH13.
bits : 28 - 28 (1 bit)
access : read-write
CAIE : Channel Acquisition Interrupt Enable / Clear
bits : 29 - 29 (1 bit)
access : read-write
CAIF : Channel acquisition interrupt flag
bits : 30 - 30 (1 bit)
access : read-only
TSUSP : Suspend Timer Mode
bits : 31 - 31 (1 bit)
access : read-write
Is something missing? Is something wrong? can you help correct it ? Please contact us at info@chipselect.org !
This website is sponsored by Embeetle, an IDE designed from scratch for embedded software developers.