\n
address_offset : 0x0 Bytes (0x0)
size : 0x2000 byte (0x0)
mem_usage : registers
protection : not protected
Serial Channel Control Register
address_offset : 0x0 Bytes (0x0)
size : 32 bit
access : read-write
reset_value : 0x0
reset_Mask : 0x0
RI : Receive Interrupt Flag
bits : 0 - -1 (0 bit)
access : read-write
TI : Transmit Interrupt Flag
bits : 1 - 0 (0 bit)
access : read-write
RB8 : Serial Port Receiver Bit 9
bits : 2 - 1 (0 bit)
access : read-write
TB8 : Serial Port Transmitter Bit 9
bits : 3 - 2 (0 bit)
access : read-write
REN : Enable Receiver of Serial Port
bits : 4 - 3 (0 bit)
access : read-write
Enumeration:
0b0 : value1
Serial reception is disabled.
0b1 : value2
Serial reception is enabled.
End of enumeration elements list.
SM2 : Enable Serial Port Multiprocessor Communication in Modes 2 and 3
bits : 5 - 4 (0 bit)
access : read-write
SM1_SM0 : Serial Port Operating Mode Selection
bits : 6 - 6 (1 bit)
access : read-write
Enumeration:
0b00 : value1
Mode 0: 8-bit shift register, fixed baud rate (fPCLK/2).
0b01 : value2
Mode 1: 8-bit UART, variable baud rate.
0b10 : value3
Mode 2: 9-bit UART, fixed baud rate (fPCLK/64 or fPCLK/32).
0b11 : value4
Mode 3: 9-bit UART, variable baud rate.
End of enumeration elements list.
Serial Data Buffer
address_offset : 0x4 Bytes (0x0)
size : 32 bit
access : read-write
reset_value : 0x0
reset_Mask : 0x0
VAL : Serial Interface Buffer Register
bits : 0 - 6 (7 bit)
access : read-write
Serial Channel Control Clear Register
address_offset : 0x8 Bytes (0x0)
size : 32 bit
access : read-write
reset_value : 0x0
reset_Mask : 0x0
RICLR : Receive Interrupt Clear Flag
bits : 0 - -1 (0 bit)
access : write-only
TICLR : Transmit Interrupt Clear Flag
bits : 1 - 0 (0 bit)
access : write-only
Is something missing? Is something wrong? can you help correct it ? Please contact us at info@chipselect.org !
This website is sponsored by Embeetle, an IDE designed from scratch for embedded software developers.