Embeetle, an IDE designed from scratch for embedded software developers.address_offset : 0x0 Bytes (0x0)
size : 0x50 byte (0x0)
mem_usage : registers
protection : not protected
Port 2 ADC Selection Control Register
address_offset : 0x0 Bytes (0x0)
size : 32 bit
access : read-write
reset_value : 0x0
reset_Mask : 0x0
ADC1_CH1_SEL : ADC1 Channel 1 Input Selection
bits : 10 - 9 (0 bit)
access : read-write
Enumeration:
0b1 : CS_AMP
Current Sense Amplifier is conncted to Ch1 of ADC1
End of enumeration elements list.
Temperature Sensor Control Register
address_offset : 0x10 Bytes (0x0)
size : 32 bit
access : read-write
reset_value : 0x0
reset_Mask : 0x0
PMU_OTWARN_STS : PMU Regulator Overtemperature Warning (MU) Status
bits : 4 - 3 (0 bit)
access : read-only
Enumeration:
0b0 : INACTIVE
write clears status
0b1 : ACTIVE
interrupt status set
End of enumeration elements list.
PMU_OT_STS : PMU Regulator Overtemperature (MU) Status
bits : 5 - 4 (0 bit)
access : read-only
Enumeration:
0b0 : INACTIVE
write clears status
0b1 : ACTIVE
interrupt status set
End of enumeration elements list.
SYS_OTWARN_STS : System Overtemperature Warning (MU) Status
bits : 6 - 5 (0 bit)
access : read-only
Enumeration:
0b0 : INACTIVE
write clears status
0b1 : ACTIVE
interrupt status set
End of enumeration elements list.
SYS_OT_STS : System Overtemperature (MU) Status
bits : 7 - 6 (0 bit)
access : read-only
Enumeration:
0b0 : INACTIVE
write clears status
0b1 : ACTIVE
interrupt status set
End of enumeration elements list.
Reference 1 Status Register
address_offset : 0x14 Bytes (0x0)
size : 32 bit
access : read-write
reset_value : 0x0
reset_Mask : 0x0
REFBG_LOTHWARN_STS : Status for Undervoltage Threshold Measurement of internal VAREF
bits : 4 - 3 (0 bit)
access : read-only
Enumeration:
0b0 : UPPER_TRIG_RESET
write clears status
0b1 : UPPER_TRIG_SET
trigger status set
End of enumeration elements list.
REFBG_UPTHWARN_STS : Status for Overvoltage Threshold Measurement of internal VAREF
bits : 5 - 4 (0 bit)
access : read-only
Enumeration:
0b0 : UPPER_TRIG_RESET
write clears status
0b1 : UPPER_TRIG_SET
trigger status set
End of enumeration elements list.
Reference 2 Control Register
address_offset : 0x18 Bytes (0x0)
size : 32 bit
access : read-write
reset_value : 0x0
reset_Mask : 0x0
VREF5V_PD_N : ADC1 Bit Reference Voltage Generation Power Down Bit
bits : 0 - -1 (0 bit)
access : read-write
Enumeration:
0b0 : DISABLED
Power Down
0b1 : ACTIVE
no Power Down
End of enumeration elements list.
VREF5V_OVL_STS : ADC1 Bit Reference Voltage Generation Over Load Bit
bits : 1 - 0 (0 bit)
access : read-only
Enumeration:
0b0 : no_OVERLOAD
no OVERLOAD detected
0b1 : OVERLOAD
OVERLOAD detected
End of enumeration elements list.
VREF5V_UV_STS : ADC1 Bit Reference Voltage Generation Undervoltage Bit
bits : 2 - 1 (0 bit)
access : read-only
Enumeration:
0b0 : no_Undervoltage
no Undervoltage detected
0b1 : Undervoltage
Undervoltage detected
End of enumeration elements list.
VREF5V_OV_STS : ADC1 Bit Reference Voltage Generation Overvoltage Bit
bits : 3 - 2 (0 bit)
access : read-only
Enumeration:
0b0 : no_Overvoltage
no Overvoltage detected
0b1 : Overvoltage
Overvoltage detected
End of enumeration elements list.
Supply Sense Control Register
address_offset : 0x4 Bytes (0x0)
size : 32 bit
access : read-write
reset_value : 0x0
reset_Mask : 0x0
VMON_SEN_PD_N : Monitoring Input Attenuator enable
bits : 0 - -1 (0 bit)
access : read-write
Enumeration:
0b0 : DISABLE
Attenuator switched off
0b1 : ENABLE
Attenuator switched on
End of enumeration elements list.
VMON_SEN_HRESO_5V : Monitoring Input Attenuator High Impedance Output Control
bits : 4 - 3 (0 bit)
access : read-write
Enumeration:
0b0 : High_Resistive_Output_Disable
Connection to ADC input low ohmic
0b1 : High_Resistive_Output_Enable
Connection to ADC input high ohmic
End of enumeration elements list.
VMON_SEN_SEL_INRANGE : Monitoring Input Attenuator Select Inputrange
bits : 5 - 4 (0 bit)
access : read-write
Enumeration:
0b0 : range0
0-18V range is selected
0b1 : range1
0-28V range is selected
End of enumeration elements list.
Current Sense Amplifier Control Register
address_offset : 0xC Bytes (0x0)
size : 32 bit
access : read-write
reset_value : 0x0
reset_Mask : 0x0
EN : OPA enable
bits : 0 - -1 (0 bit)
access : read-write
Enumeration:
0b0 : DISABLE
OPA switched off
0b1 : ENABLE
OPA switched on
End of enumeration elements list.
GAIN : OPA gain setting
bits : 1 - 1 (1 bit)
access : read-write
Enumeration:
0x0 : value_0
Gain_10
0x1 : value_1
Gain_20
0x2 : value_2
Gain_40
0x3 : value_3
Gain_60
End of enumeration elements list.
VZERO : Current Sense Output Voltage Level to Ground
bits : 8 - 7 (0 bit)
access : read-write
Enumeration:
0b0 : VOUT
Output Voltage is VOUT of Amplifier
0b1 : GROUND
Output Voltage is Ground of Feedback Network
End of enumeration elements list.
Is something missing? Is something wrong? can you help correct it ? Please contact us at info@chipselect.org !
This website is sponsored by Embeetle, an IDE designed from scratch for embedded software developers.