\n
address_offset : 0x0 Bytes (0x0)
size : 0x1000 byte (0x0)
mem_usage : registers
protection : not protected
1-Wire Master Configuration
address_offset : 0x0 Bytes (0x0)
access : read-write
reset_value : 0x0
reset_Mask : 0x0
long_line_mode : Long Line Mode
bits : 0 - 0 (1 bit)
access : read-write
Enumeration:
End of enumeration elements list.
force_pres_det : Force Line During Presence Detect
bits : 1 - 2 (2 bit)
access : read-write
Enumeration:
End of enumeration elements list.
bit_bang_en : Bit Bang Enable
bits : 2 - 4 (3 bit)
access : read-write
Enumeration:
End of enumeration elements list.
ext_pullup_mode : Provide an extra output to control an external pullup.
bits : 3 - 6 (4 bit)
access : read-write
Enumeration:
End of enumeration elements list.
ext_pullup_enable : Enable External Pullup
bits : 4 - 8 (5 bit)
access : read-write
Enumeration:
End of enumeration elements list.
single_bit_mode : Enable Single Bit TX/RX Mode
bits : 5 - 10 (6 bit)
access : read-write
Enumeration:
End of enumeration elements list.
overdrive : Enables overdrive speed for 1-Wire operations.
bits : 6 - 12 (7 bit)
access : read-write
Enumeration:
End of enumeration elements list.
int_pullup_enable : Enable internal pullup.
bits : 7 - 14 (8 bit)
access : read-write
Enumeration:
End of enumeration elements list.
1-Wire Master Interrupt Flags
address_offset : 0x10 Bytes (0x0)
access : read-write
reset_value : 0x0
reset_Mask : 0x0
ow_reset_done : OW Reset Sequence Completed
bits : 0 - 0 (1 bit)
access : read-write
Enumeration:
End of enumeration elements list.
tx_data_empty : Tx Data Empty Interrupt Flag
bits : 1 - 2 (2 bit)
access : read-write
Enumeration:
End of enumeration elements list.
rx_data_ready : Rx Data Ready Interrupt Flag
bits : 2 - 4 (3 bit)
access : read-write
Enumeration:
End of enumeration elements list.
line_short : OW Line Short Detected Interrupt Flag
bits : 3 - 6 (4 bit)
access : read-write
Enumeration:
End of enumeration elements list.
line_low : OW Line Low Detected Interrupt Flag
bits : 4 - 8 (5 bit)
access : read-write
Enumeration:
End of enumeration elements list.
1-Wire Master Interrupt Enables
address_offset : 0x14 Bytes (0x0)
access : read-write
reset_value : 0x0
reset_Mask : 0x0
ow_reset_done : OW Reset Sequence Completed
bits : 0 - 0 (1 bit)
access : read-write
Enumeration:
End of enumeration elements list.
tx_data_empty : Tx Data Empty Interrupt Enable
bits : 1 - 2 (2 bit)
access : read-write
Enumeration:
End of enumeration elements list.
rx_data_ready : Rx Data Ready Interrupt Enable
bits : 2 - 4 (3 bit)
access : read-write
Enumeration:
End of enumeration elements list.
line_short : OW Line Short Detected Interrupt Enable
bits : 3 - 6 (4 bit)
access : read-write
Enumeration:
End of enumeration elements list.
line_low : OW Line Low Detected Interrupt Enable
bits : 4 - 8 (5 bit)
access : read-write
Enumeration:
End of enumeration elements list.
1-Wire Master Clock Divisor
address_offset : 0x4 Bytes (0x0)
access : read-write
reset_value : 0x0
reset_Mask : 0x0
divisor : Clock Divisor for 1MHz
bits : 0 - 7 (8 bit)
access : read-write
Enumeration:
End of enumeration elements list.
1-Wire Master Control/Status
address_offset : 0x8 Bytes (0x0)
access : read-write
reset_value : 0x0
reset_Mask : 0x0
start_ow_reset : Start OW Reset
bits : 0 - 0 (1 bit)
access : read-write
Enumeration:
End of enumeration elements list.
sra_mode : SRA Mode
bits : 1 - 2 (2 bit)
access : read-write
Enumeration:
End of enumeration elements list.
bit_bang_oe : Bit Bang Output Enable
bits : 2 - 4 (3 bit)
access : read-write
Enumeration:
End of enumeration elements list.
ow_input : OW Input State
bits : 3 - 6 (4 bit)
access : read-only
Enumeration:
End of enumeration elements list.
presence_detect : Presence Pulse Detected
bits : 7 - 14 (8 bit)
access : read-write
Enumeration:
End of enumeration elements list.
1-Wire Master Data Buffer
address_offset : 0xC Bytes (0x0)
access : read-write
reset_value : 0x0
reset_Mask : 0x0
tx_rx : Tx/Rx Buffer
bits : 0 - 7 (8 bit)
access : read-write
Enumeration:
End of enumeration elements list.
Is something missing? Is something wrong? can you help correct it ? Please contact us at info@chipselect.org !
This website is sponsored by Embeetle, an IDE designed from scratch for embedded software developers.