Embeetle, an IDE designed from scratch for embedded software developers.address_offset : 0x0 Bytes (0x0)
size : 0xC byte (0x0)
mem_usage : registers
protection : not protected
Comparator Control Register 0
address_offset : 0x0 Bytes (0x0)
access : read-write
reset_value : 0x0
reset_Mask : 0x0
CMPEN : Comparator Enable\nComparator output needs to wait 2 us stable time after CMPEN is set.
bits : 0 - 0 (1 bit)
access : read-write
Enumeration:
#0 : 0
Disabled
#1 : 1
Enabled
End of enumeration elements list.
CMPIE : Comparator Interrupt Enable
bits : 1 - 1 (1 bit)
access : read-write
Enumeration:
#0 : 0
Interrupt function Disabled
#1 : 1
Interrupt function Enabled
End of enumeration elements list.
CMP_HYSEN : Comparator Hysteresis Enable
bits : 2 - 2 (1 bit)
access : read-write
Enumeration:
#0 : 0
Hysteresis function Disabled (Default)
#1 : 1
Hysteresis function Enabled. The typical range is 20mV
End of enumeration elements list.
CMPCN : Comparator negative input selection
bits : 4 - 4 (1 bit)
access : read-write
Enumeration:
#0 : 0
The ACMPx_N, x=0, 1, 2 or 3, is selected as the source of negative comparator input
#1 : 1
The internal band-gap reference voltage is selected as the source of negative comparator input
End of enumeration elements list.
Comparator Control Register 1
address_offset : 0x4 Bytes (0x0)
access : read-write
reset_value : 0x0
reset_Mask : 0x0
Comparator Status Register
address_offset : 0x8 Bytes (0x0)
access : read-write
reset_value : 0x0
reset_Mask : 0x0
Is something missing? Is something wrong? can you help correct it ? Please contact us at info@chipselect.org !
This website is sponsored by Embeetle, an IDE designed from scratch for embedded software developers.