\n
address_offset : 0x0 Bytes (0x0)
size : 0x100 byte (0x0)
mem_usage : registers
protection : not protected
Flash Memory Data Register
address_offset : 0x10 Bytes (0x0)
size : 32 bit
access : read-write
reset_value : 0x0
reset_Mask : 0x0
FDATA : Flash PGM data
bits : 0 - 31 (32 bit)
Flash Memory Timer Register
address_offset : 0x14 Bytes (0x0)
size : 32 bit
access : read-write
reset_value : 0x0
reset_Mask : 0x0
TMR : Erase/PGM timer
bits : 0 - 15 (16 bit)
Flash Memory Dirty bit Register
address_offset : 0x18 Bytes (0x0)
size : 32 bit
access : read-write
reset_value : 0x0
reset_Mask : 0x0
FDRTY : Write any value,cache line fill falg will be cleared
bits : 0 - 31 (32 bit)
Flash Memory Tick Timer register
address_offset : 0x1C Bytes (0x0)
size : 32 bit
access : read-write
reset_value : 0x0
reset_Mask : 0x0
FTICK : TICK
bits : 0 - 17 (18 bit)
Flash Memory CRC value register
address_offset : 0x20 Bytes (0x0)
size : 32 bit
access : read-write
reset_value : 0x0
reset_Mask : 0x0
CRC : CRC16 Value
bits : 0 - 15 (16 bit)
Flash Memory Config value register
address_offset : 0x30 Bytes (0x0)
size : 32 bit
access : read-write
reset_value : 0x0
reset_Mask : 0x0
TRIM : FLASH TRIM value
bits : 0 - 3 (4 bit)
CRCEN : Enable CRC calculation at flash read
bits : 6 - 6 (1 bit)
CRCINIT : Initialize CRC register
bits : 7 - 7 (1 bit)
WAIT : Wait for Flash Access
bits : 8 - 10 (3 bit)
TMRCK : PGM/ERASE Timer source
bits : 12 - 12 (1 bit)
HRESPD : Disable AMBA AHB signal (error response)
bits : 15 - 15 (1 bit)
WRITEKEY : Write Key (0x7858)
bits : 16 - 31 (16 bit)
Flash Memory Mode Register
address_offset : 0x4 Bytes (0x0)
size : 32 bit
access : read-write
reset_value : 0x0
reset_Mask : 0x0
ACODE : Flash Mode/Trim Mode
bits : 0 - 7 (8 bit)
access : read-write
FMOD : Flash Mode status
bits : 8 - 8 (1 bit)
access : read-only
FEMOD : Flash Mode entry status
bits : 9 - 9 (1 bit)
access : read-only
TRM : Trim Mode status
bits : 16 - 16 (1 bit)
access : read-only
TRMEN : Trim Mode entry status
bits : 17 - 17 (1 bit)
access : read-only
AMBAEN : AMBA mode enable
bits : 22 - 22 (1 bit)
access : read-write
VERIFY : Flash verify Mode enable status
bits : 23 - 23 (1 bit)
access : read-write
IDLE : Idle mode enable status
bits : 24 - 24 (1 bit)
access : read-only
BOOT : Boot Mode enable status
bits : 31 - 31 (1 bit)
access : read-only
Boot ROM Remap Clear Register
address_offset : 0x74 Bytes (0x0)
size : 32 bit
access : read-write
reset_value : 0x0
reset_Mask : 0x0
BOOTROM : Used to clear Boot mode at end of boot code
bits : 0 - 0 (1 bit)
Internal flash memory protection Register
address_offset : 0x78 Bytes (0x0)
size : 32 bit
access : read-write
reset_value : 0x0
reset_Mask : 0x0
WP0 : 0x0000-0x0FFF
bits : 0 - 0 (1 bit)
WP1 : 0x1000-0x1FFF
bits : 1 - 1 (1 bit)
WP2 : 0x2000-0x2FFF
bits : 2 - 2 (1 bit)
WP3 : 0x3000-0x3FFF
bits : 3 - 3 (1 bit)
WP4 : 0x4000-0x4FFF
bits : 4 - 4 (1 bit)
WP5 : 0x5000-0x5FFF
bits : 5 - 5 (1 bit)
WP6 : 0x6000-0x6FFF
bits : 6 - 6 (1 bit)
WP7 : 0x7000-0x7FFF
bits : 7 - 7 (1 bit)
WP8 : 0x8000-0x8FFF
bits : 8 - 8 (1 bit)
WP9 : 0x9000-0x9FFF
bits : 9 - 9 (1 bit)
WP10 : 0xA000-0xAFFF
bits : 10 - 10 (1 bit)
WP11 : 0xB000-0xBFFF
bits : 11 - 11 (1 bit)
WP12 : 0xC000-0xCFFF
bits : 12 - 12 (1 bit)
WP13 : 0xD000-0xDFFF
bits : 13 - 13 (1 bit)
WP14 : 0xE000-0xEFFF
bits : 14 - 14 (1 bit)
WP15 : 0xF000-0xFFFF
bits : 15 - 15 (1 bit)
PAS : Protection Area Selection
bits : 16 - 18 (3 bit)
APR : Enable/Remove all protection
bits : 23 - 23 (1 bit)
WRITEKEY : Write Key
bits : 24 - 31 (8 bit)
JTAG Protection Control Register
address_offset : 0x7C Bytes (0x0)
size : 32 bit
access : read-write
reset_value : 0x0
reset_Mask : 0x0
JTAGEN : JTAG enable
bits : 0 - 0 (1 bit)
WRITE_KEY : Write Key (0xC7)
bits : 24 - 31 (8 bit)
Flash Memory Control Register
address_offset : 0x8 Bytes (0x0)
size : 32 bit
access : read-write
reset_value : 0x0
reset_Mask : 0x0
PBR : page buffer reset
bits : 0 - 0 (1 bit)
access : read-write
ERS : program mode/erase mode Enable
bits : 1 - 1 (1 bit)
access : read-write
PGM : PGM
bits : 2 - 2 (1 bit)
access : read-write
PBLD : page buffer load
bits : 3 - 3 (1 bit)
access : read-write
WE : write Enable
bits : 4 - 4 (1 bit)
access : read-write
PMODE : Pmode Enable
bits : 5 - 5 (1 bit)
access : read-write
AE : All Erase
bits : 8 - 8 (1 bit)
access : read-only
PPGM : PreProgram enable
bits : 9 - 9 (1 bit)
access : read-write
PVER : Set Program Verify mode
bits : 13 - 13 (1 bit)
access : read-write
EVER : Set Erase Verify mode
bits : 14 - 14 (1 bit)
access : read-write
VPPOUT : Enable Charge pump VPP output
bits : 15 - 15 (1 bit)
access : read-write
TEST : TEST
bits : 16 - 17 (2 bit)
access : read-write
TIMER : Program/Erase Timer enable
bits : 20 - 20 (1 bit)
access : read-write
Flash Memory Address Register
address_offset : 0xC Bytes (0x0)
size : 32 bit
access : read-write
reset_value : 0x0
reset_Mask : 0x0
FADDR : 96K 4-byte word address
bits : 0 - 16 (17 bit)
Is something missing? Is something wrong? can you help correct it ? Please contact us at info@chipselect.org !
This website is sponsored by Embeetle, an IDE designed from scratch for embedded software developers.