\n
address_offset : 0x0 Bytes (0x0)
size : 0xD byte (0x0)
mem_usage : registers
protection :
LIN Transmission Control Register
address_offset : 0x0 Bytes (0x0)
size : 8 bit
access : read-write
reset_value : 0x0
SBFSEL : Synch Break field transmission width selection
bits : 0 - 2 (3 bit)
access : read-write
SBFEN : Synch Break field transmission trigger/monitor(*1)
bits : 3 - 6 (4 bit)
access : read-write
TXCHSST : Check sum operation for transmission
bits : 4 - 8 (5 bit)
access : read-write
BITERREN : Bit error detection function selection
bits : 5 - 10 (6 bit)
access : read-write
__reserve0 : 0 is always read out.
bits : 6 - 13 (8 bit)
access : read
LIN Reception Control Register
address_offset : 0x1 Bytes (0x0)
size : 8 bit
access : read-write
reset_value : 0x0
LINEN : LIN communication enable
bits : 0 - 0 (1 bit)
access : read-write
SBFREC : Wake up signal and Synch Break field reception enable
bits : 1 - 2 (2 bit)
access : read-write
SFREC : Synch field reception enable
bits : 2 - 4 (3 bit)
access : read-write
SBFBSY : Synch Break field reception busy
bits : 3 - 6 (4 bit)
access : read
SFBSY : Synch field reception busy
bits : 4 - 8 (5 bit)
access : read
RXCHSST : Check sum operation for reception
bits : 5 - 10 (6 bit)
access : read-write
__reserve0 : This bit must be set to 0 .
bits : 6 - 12 (7 bit)
access : read-write
TMIOSEL : Selection of clock source for Timer 0
bits : 7 - 14 (8 bit)
access : read-write
LIN Error Status Register
address_offset : 0x4 Bytes (0x0)
size : 8 bit
access : read-write
reset_value : 0x0
BITERR : Bit error detection(*3)
bits : 0 - 0 (1 bit)
access : read
__reserve0 : 0 is always read out.
bits : 1 - 2 (2 bit)
access : read
CHKSERR : Check sum error detection(*1)(*2)
bits : 2 - 4 (3 bit)
access : read
__reserve1 : 0 is always read out.
bits : 3 - 10 (8 bit)
access : read
LIN Transmission Check sum Register
address_offset : 0x8 Bytes (0x0)
size : 8 bit
access : read-write
reset_value : 0x0
TXCHKS : Check sum value for the transmission data is read out.
bits : 0 - 7 (8 bit)
access : read
LIN Reception Check sum Register
address_offset : 0x9 Bytes (0x0)
size : 8 bit
access : read-write
reset_value : 0x0
RXCHKS : Check sum value for the reception data is read out.
bits : 0 - 7 (8 bit)
access : read
Is something missing? Is something wrong? can you help correct it ? Please contact us at info@chipselect.org !
This website is sponsored by Embeetle, an IDE designed from scratch for embedded software developers.