\n
address_offset : 0x0 Bytes (0x0)
size : 0x4 byte (0x0)
mem_usage : registers
protection :
User Configuration Memory
address_offset : 0x0 Bytes (0x0)
size : -1 bit
access : read-write
reset_value : 0x0
reset_Mask : 0x0
LOCK : Security Lock
When flash data is locked,(1) only device ID, CONFIG can be read by Writer and ICP thru serial debug interface. Other data are locked as 0xFFFFFFFF.(2) ISP can read data anywhere regardless of LOCK bit value. (3) SWD interface cannot access internal RAM and Flash
bits : 1 - 1 (1 bit)
access : read-write
Enumeration:
#0 : 0
Flash data are locked
#1 : 1
Flash data are not locked
End of enumeration elements list.
CVDTV : Voltage Detector Threshold Voltage Selection
bits : 21 - 21 (1 bit)
access : read-write
CVDEN : Voltage Detector Enable
bits : 23 - 23 (1 bit)
access : read-write
Enumeration:
#0 : 0
Enable Voltage Detector after power on
#1 : 1
Disable Voltage Detector after power on
End of enumeration elements list.
CFOSC : Power-on Clock Source Selection
bits : 24 - 26 (3 bit)
access : read-write
CKF : Clock Filter Enable
bits : 28 - 28 (1 bit)
access : read-write
Enumeration:
#0 : 0
Disable clock filter
#1 : 1
Enable clock filter
End of enumeration elements list.
CWDTEN : Watchdog Enable
bits : 31 - 31 (1 bit)
access : read-write
Enumeration:
#0 : 0
Watchdog is disabled after power on
#1 : 1
Watchdog is enabled after power on
End of enumeration elements list.
Is something missing? Is something wrong? can you help correct it ? Please contact us at info@chipselect.org !
This website is sponsored by Embeetle, an IDE designed from scratch for embedded software developers.